Systems

On my 2 most recent flights in the A330, my plane out of nowhere went into a spiral and crashed. The first flight was from JFK to Amsterdam. I was still in the climb phase. I am not sure if the spiral dive came before the auto pilot disconnect or after. The 2nd flight was from Athens to Amsterdam. I had been in cruise mode for some time. The plane deviated from course without actually disconnecting from the auto pilot. Then the spiral dive came followed by the crash. Has anyone else have any experience of this? I was looking forward to buying the A350 but I'm a bit hesitant now as I don't know if this happening across the inibuilds range of airb…

Hi there, I just had very strange problems with the A330 in MSFS 2024, when I tried to start a flight at the gate and chose the panel state "on APU": - The engines were "half running": EPR was 1.002, N3 = 30.8, N1 = 6.5, N1 = 14.9, from the outside the engine souded like they were running (and they looked like the nacelles were spinning), from the cockpit I got the engine start sounds all the time. All this while the starter switch was in the OFF position. - Engines could be started "normally" then. However, while being pushed by GSX (as many times before), an MSFS message "aircraft malfunction - gear system" showed up. I had to set more than 50% N1 to be a…

Hi, I recently started to fly the A330-300GE on Vatsim and everything worked fine, except the direct to, when ATC gives me a direct Waypoint / VOR (happens on both) the mcdu just freezes and deleted the flightplan. When I try to fix that, it just freezes all buttons and even thrust control and I have to disconnect. It nearly happens every time when I enter a direct to, so it is really annoying when it happens after 6 hours of flight and makes it basically unflyable in vatsim. My PC specs also shouldn’t be the issue: GPU: RTX4090 CPU: Intel i9 13900K RAM: 64GB ddr5 6000mhz SSD: Samsung 980 Pro 2TB Do some of you experience the sam…

I just request wind data for CRZ and all the Screen in my airplane freeze，even can`t control the plane itself,is been long time after game release,please FIX IT.

Whenever I go to land with a fully configured flight no matter the duration, variant, or where I’m landing, there are no GPSW callouts. I’ve even tried to trigger the “pull up” or “glide-slope” alarms but nothing happened. This was mainly just for landing and since I don’t have the very useful, “50, 40, 30, 20, etc…”, I can’t land very well. If anybody knows how to help, please do! Lots of thanks!

Hello, For some reason, even if I disable the Reverse on Axis in the A330 throttle calibration, the thrust reversers still activates on IDLE. I use the Thrustmaster Hotas Worthog and my reverse thrust is a button in MSFS2024 control settings. Also, I confirm that the Reverse On Axis = False in the ThrottleData.ini Any idea why this is happening? Thanks

Description as per title. Steps to reproduce. Activate Secondary. Boom, WASM crash my favourite after 6hrs of flight

I had this WASM crash when I entered the STAR of UTAA in the MCDU. To reproduce Load at gate Power on aircraft (Battery, GPU) Loaded the Simbrief Flight Plan in the MCDU Selected SID for the VGHS Selecting STAR for UTAA Systems freeze (After selecting ILS 11L) Information Aircraft: A330-300P2F (RR) Simulator: FS24 Navdata Method: NAVIGRAPH OFP: IDLOX1A IDLOX G463 RAJ A201 PPT J71 KEVOD Z2 JAL R594 SSB L626 DPN A589 BUTOP M875 JHANG A466 DI J145 REGET N644 LEMOD A909 NINOP A125 KEMOR KEM11A Specs: Ryzen 7800X3D, RX 7900 GRE, 32GB RAM WASM: WASM: Error during FMGS_gauge_update execution. Error code :…

As the title suggests, the right toe brake does not work at all. The animation works, but the brake itself does not. I tried changing bindings and axis but still didn't work. Tried the default A321NEO and both brakes work, so I can conclude that this is a bug in the actual aircraft itself.

I already tried everything, chage my ID just to NUMBERS ONLY, downloaded all the airframes available, nothing happens! please help.

the right brake pedal moves visually but no braking power can be achieved. left pedal works fine

Ok, I am reaching the end of my capacity to fix this. I want to set up a flight plan for the A330, but I find no way that works. Typing it directly in the MCDU, after doing the INIT page, I type in the departure, then as soon as I add a waypoint after the last departure waypoint (or before destination) I end up with a looped flight plan (in order: departure waypoints, destination airport, and departure waypoints again, and impossible to remove a number of them to restore order). Simbrief, after having all linked correctly, inporting in the in-cockpit EFB on the left correctly, if I try to send it directly from the Tab EFB to the airplane, it freezes the MCDU and…

Hi guys, The trim tank is not working on 330-200, as in no transfer is occurring for me.... Thanks

This was brought up in a previous topic but the topic suddenly got sidetracked onto the A400 and closed. But it’s still an issue so I want to raise it I have a great many hours in the A300 on the sim which the A330 was the replacement for. As such, it was meant to feel very similar. But the issue is that it doesn’t and to be specific, it is very hard to hold the centreline/localiser on final due to what feels like a dead zone in the roll axis control. I am using a Thrustmaster Hotas One and my friends who also flies the A300 and A330 on the sim uses the TCA Captains Pack But we both agree that the aircraft has a dead zone making it go from nothing to a large res…

When I use a higher simrate, the fuel goes down as slow as without simrate. Is there a way to fix this?

I recently did a flight from LA- Manchester (EGCC) in the a330, i calculated everything like the fuel thru simbreif, imputed the flight plan and it's saying i don't have enough fuel. I tried this on another flight with the a330 and once again it was not enough. I have never had a issue with simbreif so im wondering is this a user error by me? Id really like to fix this so i can do long hauls again I also occurred a issue with the rudder as if it wouldnt turn at all which was strange as all chocks were off and nothing was connected e.g GPU.

Default Inibuilds A332 or A333 on PC with Thrustmaster Tstick and Logitech bluetooth mouse; accessed with GamePass. Cockpit view has no mouse interaction to click controls. Mouse pointer shows, but clicking the controls does nothing. Can use right click to pan view. In outside view cold and dark startup can click engine covers, chocks and pitot covers fine and enter cockpit with shift + c, but no left mouse interactions once inside cockpit. No such problems with other Inibuilds aircraft (A321, for example). Using legacy cockpit interaction system; tried with lock cockpit interaction system and still no left mouse input. Tried with corded mouse, no change. Deleted ai…

Hello when changing qnh on the standby altimeter only the value to the left (2992) changes not the 1013

Default Inibuilds A332 or A333 on PC with Thrustmaster Tstick and Logitech bluetooth mouse; accessed with GamePass. Cockpit view has no mouse interaction to click controls. Mouse pointer shows, but clicking the controls does nothing. Can use right click to pan view. In outside view cold and dark startup can click engine covers, chocks and pitot covers fine and enter cockpit with shift + c, but no left mouse interactions once inside cockpit. No such problems with other Inibuilds aircraft (A321, for example). Using legacy cockpit interaction system; tried with lock cockpit interaction system and still no left mouse input. Tried with corded mouse, no change. Deleted ai…

Hi im having this weird issue where the A330 managed climb keeps resetting to 200 knots as shown. I already reinstalled it by deleting the a330 from the stream package folder. Any ideas?

Hello, I am currently flying with the A330-200 Paris - Pointe Noire so 8 hours of flight, I am approaching Pointe Noire, I add a Hold in the MCDU and hop! FREEEEEZZEEEEE! Bravo Inibuild! And by the way how do you explain that the airbuses were not corrected in the big update where all the planes received fixes?

FPV is false. This is the same on the ini A321.

A330-200GE. Don’t work nav lights, aft strobe light, taxi and takeoff light (at least with Delta livery from inimanager)

A330-300 Freighter (RR) Default Livery no Mods. Flying into EDDB (Berlin) MCDU has NO SID'S at all, just Via's. Other Airports i have noticed this is EGPH (Edinburgh) & EGNX (East Midlands). There ARE SID's for these Airports as i can see them in the Fenix, FBW (All their Aircraft)

Today I took off from EGLL. Initial climb to fl240. Then I literally blinked. Speed nav etc disappeared from primary flight display. The only display at the top was AP1/2. All three other areas were blank. Also heading would not engage. There was no heading indicator on the PFD. Would not capture altitude. Only manual flight was permitted. I tried disengaging and re-engaging auto throttle and autopilot. To no avail. Help