frank_m

Low-res textures are meanwhile standard. So topic closed.

You can fix it like all others with the same problems. Its described at least 10 times in the forum.

Most likely still the same as in all other threads regarding this question.

When the "Shift+C" is shown to enter the plane, just wait a few seconds till the plane and all ground equipment is fully loaded and enter then the plane. Afterwards it works reliable.

what is your setting in the OIS for the start configuration of the plane? Maybe Cold&Dark?

Seriously? There is less than 18 GB free space on your hard drive? You are aware of the fact, that you should have AT LEAST 25 - 30% of free capacity on an SSD, so the wear levelling can work efficiently? So, buy a new SSD. Or clean up your storage. The simulator with addons needs several hundred GB. BTW, the a350 needs 15 GB on the hard drive, and the download archive is 5 to 7 GB. So in total you need around 22 - 25 GB free space for installation. And as I said: Never less than 25% free capacity on a hard drive.

Where did you buy it? Maybe the plane is streamed in MSFS2024?

Rollback is not possible. Just use compatible Liveries.

You are surprised, that a MSFS2020 addon disturbs the MSFS2024? An Addon, which even the provider recommends not to install in the 2024? Really? REALLY?

Ok, then I think, I know, what happens. LT and RT are both analogue axis, so you can assign them to the tiller. BUT: LT only steers to the left, while RT only steers to the right. Since you can assign only one axis to the tiller, you will only steer in one direction and have no chance to put the tiller in neutral position again. You need a control with a regular axis, preferable one, that returns automatically to neutral position for controlling the tiller.

Which Controller do you use? What is the "normal" stick? On my controllers are 5 "normal sticks". Assign an analogue axis. "Shoulder button" sounds for me like a digital input. This will not work of course.

That is for sure a problem in your controller configuration. I use a dedicated axis on my controller for the tiller moving back to neutral position automatically and have no issues. Maybe you assigned not the analogue axis but the button event of your axis?

SU4.

I have no problem in VR using all components of the plane. Seems to be an individual problem for you.

There already a discussion ongoing:

Which mode? Cockpit Interaction System? If it is set to legacy, you get the arrows. If is set to "Lock", you get the hand.

Most likely it is still the same reason as in all other threads for this problem.

No problem here. Works like before (Simbrief Flightplan).

Its not a bug, its a feature. Cabin packs are not supported any more by intention. See the release notes of v1.1.7.

Can't confirm. I have used it today (10 nm before ToD), and it worked as intended.

You entered the Pilot ID or the Username? There is a difference at Simbrief. You have to enter the pilot ID.

Most likely no calibration or wrong assignments in the controls.

Exactly the same happens on FBW A380. So it is maybe not an issue of the plane, but a Navigraph issue.

There is a tag "PC", and the discussed topics do not occur on PCs. It is ok to discuss bugs, solutions or workarounds. But uncontrolled gossiping is not very helpful.

Quite strange. Did again a flight tonight, no issues with the Simbrief and Navigraph integration. Flightplans, Charts, OANS, BTV, ..., everything was fine.