Sounds

Dear Inibuilds team, Even with EFB PA volume set to 100% and the radio panel PA knob On and high, I am still not hearing any PA in the cockpit or cabin. I am on PC. Thank you! Reza B

Hi everyone, I've noticed a bunch of sound issues with the initial release of the A380. I'm having a hard time getting recordings of what I'm referring to, as the issues are mainly related to spatial positioning, so I hope my description is enough to explain them: Engines 3 and 4 have no exterior sounds. Or at least, the sounds aren't positioned where the engines actually are. The entire engine soundscape seems to be shifted to the left side of the aircraft, and not a single exterior sound seems to originate from Engines 3 and 4. Also, when putting these two engines into TOGA, there's no noticeable change in sound. The interior sounds are fine, though. Not only does the e…

Hello. I write it like 4 days ago but my problem was still in my aircraft. Wich is i dont have any collout in my a380. and all of my collout was turned onmy loudspeakers are at 100% and i uninstall and installed the aircraft again but still nothing. Does anyboody has that problem or just me? Aniways please help me to get it back cause it is very difficult to land an aircraft that big without any collout . Thanks!

HI, Thank you for this beautiful aircarft. Everything about the operation of the A380 works just fine, but I seem to be having some issues with GSX passengers and cargo loading. There are no seated passengers after loading and loading and unloading 480 passengers only takes a couple minutes (weird). During Cargo and luggage loading and unloading, the iniA380 doors open as expecetd, but there are no GSX ramp agents or GSE. This works fine with all other aircarfts so I am not sure how to fix this. What I tried so far was run GSX config, uncheck and recheck ini A380. *Update: After carefully looking at GSX config, I just noticed that there is NO iniA380. Was there supposed t…

Hi inibuilds team, as I was flying today I noticed that you could have cabin announcements but for some weird reason they weren’t working at all no matter what I did. Steps I Have Taken to Troubleshoot: Spawned Cold & Dark at a lightweight default airport (Hamilton Island - HTI) to rule out Xbox RAM limitations. Used the default iniBuilds House Livery (no third-party liveries). Used the EFB panel state shortcuts (ON GPU / ON APU) to power the aircraft at the gate. Opened cabin doors (1L/2L) and successfully attached the jetway. Set the EFB Audio Language manually to English (US) / English (UK) and verified the EFB volume sliders are at 100%. Verified the PA volume kno…

Hi everyone working at the inibuilds development team! I would like to report a bug I have noticed while flying your new beautiful aircraft, now I do not know if this bug is within Microsoft flight simulator or if it is the aircraft itself but every time I go into showcase mode and use the for to see my plane taking off, the planes audio is fine until it goes directly in front of me and the. It just sounds like the engines are at idle and then once it goes past me it goes back to Normal, if this is a a380 issue could you please fix this? And if this is a Microsoft issue, could you please tell me the solution to this bug? Thank you

Noticed a potential bug with the lavatory sink sounds. When you turn on the tap in one lavatory, the sound plays throughout the whole aircraft from every single lavatory, even when only one sink is running. The sounds seem to be duplicated all across the different lavatories, rather than from the single one. Sometimes you can turn one on my accident through a clickspot and the whole plane sounds like running water, which is what I experienced today. https://drive.google.com/file/d/1YOO_GIpczQUWj9ey6nZWs5W2OckqTLv-/view?usp=sharing

Like the title states the "100 above" and "minimum" callout overlap with GPWS altitude callouts. In the irl. aircraft this is obviously not the case, with the callouts being played in close sequence if applicable. Sadly this is a bug that was already present (and reported) on the A350 as well as other ini Airbus aircraft and still has found its way onto the A380.

when i select LS on the radio panel and turn up the volume i get a very low volume morse code no matter where i am or turned in to and its barely audible. the ILS morse doesnt sound at all just the same very quiet beeping thats always the same, surely this isnt how it should be?

The engine sounds from within the cockpit when starting them up, or shutting them down, are disproportionately loud and inconsistent (like a distorted booming bass rising and falling). The volume of them is otherwise ok, tested having made no adjustments during the initial din!

The same as in the A350. This is not supposed to be like this...

If I move my joystick, the autopilot disconnects, but I don't hear the usual Airbus autopilot disconnect warning sound.

Hello, I would like to report two sound-related issues: .The RAAS "on taxiway" announcements are not working, whereas the runway approach and runway announcements are working fine. .Cabin announcements cannot be heard in either the cockpit or the passenger cabin, despite the noise-cancelling headset not being active in the simulator (EFB) and the PA volume button being turned on and fully maximized. Hopefully these can be looked into. Thank you! (Xbox Series X)

Hello, I recently purchased the A380, but I am not receiving any GPWS sounds. I have restarted the simulator multiple times, but the issue persists (as shown in the attached video). Any help resolving this would be appreciated. WhatsApp Video 2026-09-15 at 9.43.25 PM.mp4