frank_m

Have you linked your Navigraph account in the A350? Is the Navigraph subscription detected?

Please show screenshots. I have never observed missed constraints.

You are right, there are no dots, but the dashed lines for spd and heading show the managed mode. And in managed mode the A350 observes all constraints. I did a flight today, and it worked perfectly. In the MFD you see the upper and lower constraints of each waypoint and the descend path observing it.

Yes, it has. And if everything is programmed correct, speed and heading are dashed. Of course the A350 calculates the descend path in an optimized way, but it observes for sure all constraints. If you do not have dashed speed and heading displays and the plane is not observing the constraints of the flightplan, then the MCDU is not programmed correctly.

If the flight plan is correct, the A350 will of course observe waypoint constraints in terms of both altitude and speed. I have no problems with this, even with the latest release. Please provide screenshots. If your glareshield shows no dashed lines for speed or heading, then the MCDU is most likely not programmed correctly. Perhaps the PERF setup is missing?

You must activate vsync in the graphic driver. It is not possible to activate it in the game. And you must save VRAM, in the game and by closing external VRAM consumers.

16 GB VRAM is tough for large Airliners and complex airports. Save VRAM by using low-res textures and close all other apps using VRAM. It depends heavily on your Monitor setup if you see stutters or not. Ensure a proper freesync/vsync setup, that is crucial.

I just did an Autoland in EDDL without any issues. Decelerated Climb active?

Maybe this is the Navigraph issue already discussed in this forum?

Do all your addons have a correct "package_order_hint" entry? If not, this may lead to missing STARS, SIDs or erroneous ILS approaches.

Of course it uses more resources than a GA plane, but compared to other large airliners (Fenix, FBW A380, ...) it is on the same level. FBW uses even more VRAM.

Do all your add-ons have an appropriate "package_order_hint" entry in the manifest.json? In particular for add-ons not designed exclusively for MSFS2024 this entry is missing very often. In this case the Navigraph Navdata is not working correctly, missing SIDs, STARs are the consequence, or ILS is not working any more. So make sure, ALL add-ons have this entry. Details and the technical reasoning behind it can be found in the Navigraph forum.

I have today performed a flight from EDDL to EDDM 08L and had no issues with ILS. Of course without Navigraph Navdata.

I can also confirm the issue.

Please show screenshots from each step from the MCDU. I didn't understand, what you are doing.

Cant confirm. I have made a flight today, and retracting the flaps was no problem.

ILS is working perfectly for me. So I doubt you are doing everything correct.

Due to the problems with other planes (more or less all planes delivered with the simulator are unusable currently), I think, this has to be fixed by Microsoft.

Yes, I can confirm, the workaround works.

So you can tune the radio, but you can't communicate? Also, if you manually tune the radio? If the frequency is shown, the radio is tuned. So it seems, you don't have an issue with tuning, but with communication. Right? BTW, it works with BATC, so it is most likely not an issue with the radios, but with the ATC.

How?

That is a chart, a document. For BTV you need Vector Data.

You can update the AIRAC Cycle in the A350, but need a Navigraph subscription.

Why not entering the fuel amount in Simbrief?