I have the Honeycomb Bravo and I can't seem to calibrate it properly for the A380. quite confusing . The throttles seems to shake even after calibrating on the PC.

1 hour ago, muttley said:

I have the Honeycomb Bravo and I can't seem to calibrate it properly for the A380. quite confusing . The throttles seems to shake even after calibrating on the PC.

https://forum.inibuilds.com/topic/40785-how-to-calibrate-my-throttles/

Hello, did the above guide help?

i'm still a bit confused on which one of those shown I can use for the honeycomb bravo. very confusing. I copied the Fenix settings using two throttles controlling the 4 engines with the two inboards using throttle decrease and prev detent ,

I think I got it but the throttles are a bit wanky and not even when accelerating through detents

2 hours ago, muttley said:

I think I got it but the throttles are a bit wanky and not even when accelerating through detents

Hi,

After re-configuring your throttles, please re-do the calibration in the aircraft and restart your sim.

Thanks!

I am also having issues its like the "throw" of the axis is super short and no adjustment of the sensitivities will fix it, as in I barely move the axis and it goes through the entire gambit from CLB to TOGA all in like a 1/2 an inch

Edited September 16Sep 16 by boozysheep

2 hours ago, boozysheep said:

I am also having issues its like the "throw" of the axis is super short and no adjustment of the sensitivities will fix it, as in I barely move the axis and it goes through the entire gambit from CLB to TOGA all in like a 1/2 an inch

Hi,

Just want to confirm you have the AXIS set to Throttle 1 not Throttle 1 (1-100%)?

Thanks!

sorry had to work for a few days but yes its set to AXIS and not 1-100%. I could send a video perhaps if it helps.

see how it piles them all up at the bottom of the gauge

18 hours ago, boozysheep said:

see how it piles them all up at the bottom of the gauge

I'm not sure why it is bundling them all together like that. I'll do some further investigating on my end.

Thanks for your patience!

43 minutes ago, iniKyle said:

I'm not sure why it is bundling them all together like that. I'll do some further investigating on my end.

Thanks for your patience!

Thank you so much, other than this small issue I am loving the plane. Great job by yall!

On 9/21/2026 at 8:42 AM, iniKyle said:

I'm not sure why it is bundling them all together like that. I'll do some further investigating on my end.

Thanks for your patience!

any word about this, I tried the a350 today and it works perfect if that helps at all lol

7 minutes ago, boozysheep said:

any word about this, I tried the a350 today and it works perfect if that helps at all lol

Nothing new to report.

On a side note, are you trying to use the same profile you use with other aircraft? I yes, could you try making a new profile specifically for the A380?

Thanks!

I am still having problems, there is a lot of space between FLEX and TOGA on my Honeycomb bravo.

Does your device have four engine thrust increase levers or two? The tablet shows that four have been selected.