Cannot get engine pressure to start engines.

[Brit]

Hi

I set up everything correctly but i still have no pressure to start the engines? Am i missing something?

Was fine before the update.

Here are a couple screenshots.

Thanks

[adiole757]

Did you use autocomplete?

eng 1 and 3 isln valve off

crossbleed off

when eng 2 is running crossbleed on

isln valve 2 off valve 1 on and start eng 1 and so on 

see checklist in EFB. It is really good to use

Edited Saturday at 05:41 PM by adiole757

[Brit]

Yes i did.

[Acktu]

By any chance, prior to you trying to start the engines, did you select cold & dark panel state from the PFB?  I say that because whenever I select that state, I can't start the engines, I would have to quit the flight and reload.

Edited Saturday at 08:19 PM by Acktu

[Brit]

3 hours ago, adiole757 said:

Did you use autocomplete?

eng 1 and 3 isln valve off

crossbleed off

when eng 2 is running crossbleed on

isln valve 2 off valve 1 on and start eng 1 and so on 

see checklist in EFB. It is really good to use

Tried that still doesn't work.

[RyanAlmeida95]

Have you tried cycling all the APU BLEED AIR S/O, All HI BLEED, All ENG ISLN VALVE, ISLN VALVE, Both CROSS BLEED and All PACK FLOW CONTROL to be unlatched then latched again? Just to make sure the aircraft didn't load with buttons confused in the wrong position? 

After that, can you just try the below config and hit ENG2 start? If that doesn't supply everything possible to ENG2 then its someting else broken 😅

[Brit]

No luck, out of ideas now!

I tried panel state with engines running and the engines start somehow lol

[RyanAlmeida95]

Hm, If you unlatch APU BLEED AIR S/O does air pressure drop on all PSIG gauges? (Checking that actually works)

Separately with everything set normally, when you click on GND START does the switch illuminate green and stay on or does it just unlatch automatically after a second or so?