A340 - Reverse Throttle Calibration - Honeycomb Bravo - 2 Axis

[Spencer te Wildt]

I am having a really challenging time getting my reverse throttle to work properly with my honeycomb bravo.

I am able to successfully engage all reversers - but when I disengage - only throttles 1 and 4 regain power. See here: https://www.youtube.com/watch?v=Qz6Fj1FKvU8

I am using my bravo in a 2 axis configuration (having the 3rd axis control engines 1/2, and the 4th axis control engines 3/4). 

Interestingly, I have found that this behavior does not persist when I swap over to using 4 axes on my bravo (having 1 axis assigned to each engine).

I have tried:
https://www.youtube.com/watch?v=rvLUPkUhniE - This may not be applicable though, as it is treating the user as using 4 throttles
https://forum.inibuilds.com/topic/33760-how-to-calibrate-my-throttles/ - no change in performance between Toggle/Hold/Decrease

Any help would be greatly appreciated.

Cross posted from discord - appologies, not sure which one is appropriate to come to for asking for support.

[Cule1899]

I have the same issue… Been trying for hours now but haven‘t found a solution. 

[Dav_id]

Same Issue here as well. Anyone know how to fix this? 

[RussD]

I have this issue too. Has anyone found a solution?

[IniJamir]

Hello

Sorry for the delays in response, I will pass this information along to the team

[JustSamuel]

Has anyone found a solution?

[C. Schaffhausen]

I don't have a solution for you but I also use the Honeycomb Bravo with 4 axis for the engines. It had a different problem though with the Master caution sounding "Flaps not in T.O. config" after landing. My config can be found in this post.

[Spencer te Wildt]

Is there any update on this? This has been an issue for months now, with no update.

[IniJamir]

18 hours ago, Spencer te Wildt said:

Is there any update on this? This has been an issue for months now, with no update.

I'll ask the team about this and get back to you when I get more info