I am having a really challenging time getting my reverse throttle to work properly with my honeycomb bravo.

I am able to successfully engage all reversers - but when I disengage - only throttles 1 and 4 regain power. See here: https://www.youtube.com/watch?v=Qz6Fj1FKvU8

I am using my bravo in a 2 axis configuration (having the 3rd axis control engines 1/2, and the 4th axis control engines 3/4). 

Interestingly, I have found that this behavior does not persist when I swap over to using 4 axes on my bravo (having 1 axis assigned to each engine).

I have tried:
https://www.youtube.com/watch?v=rvLUPkUhniE - This may not be applicable though, as it is treating the user as using 4 throttles
https://forum.inibuilds.com/topic/33760-how-to-calibrate-my-throttles/ - no change in performance between Toggle/Hold/Decrease

Any help would be greatly appreciated.

Cross posted from discord - appologies, not sure which one is appropriate to come to for asking for support.

I have the same issue… Been trying for hours now but haven‘t found a solution. 

Same Issue here as well. Anyone know how to fix this? 

I have this issue too. Has anyone found a solution?

Hello

Sorry for the delays in response, I will pass this information along to the team

Has anyone found a solution?

I don't have a solution for you but I also use the Honeycomb Bravo with 4 axis for the engines. It had a different problem though with the Master caution sounding "Flaps not in T.O. config" after landing. My config can be found in this post.

Is there any update on this? This has been an issue for months now, with no update.

18 hours ago, Spencer te Wildt said:

Is there any update on this? This has been an issue for months now, with no update.

I'll ask the team about this and get back to you when I get more info

Checking in again...