I saw that the recent 1.0.6 update addressed a bug I reported regarding the reverse animation not happening when activating reverse using the joystick method that uses the HOLD THROTTLE REVERSE THRUST button.

Reverse thrust animation not working - Systems - iniBuilds Forum

It turns out the update '''solved'' this bug by creating another one. Now, when I activate the button assigned for HOLD THROTTLE REVERSE THRUST on the joystick, instead of simply making the throttles to enter reverse mode so I can control the reverse power via the throttle axis, it activates full reverse instead, and I can't control the power via axis, which is totally counterintuitive.

This is the 3rd different bug I've encountered regarding reverse in iniBuilds L1011. I hope I don't have to come back here again to report the 4th.

Edited 12 hours ago12 hr by edu2703
Small change for better clarity

I have this behaviour too.

9 hours ago, edu2703 said:

It turns out the update '''solved'' this bug by creating another one. Now, when I activate the button assigned for HOLD THROTTLE REVERSE THRUST on the joystick, instead of simply making the throttles to enter reverse mode so I can control the reverse power via the throttle axis, it activates full reverse instead, and I can't control the power via axis, which is totally counterintuitive.

Can I suggest setting it to TOGGLE THROTTLE REVERSE THRUST instead for this function? If its a button you intend to use while its held, set it to toggle both ON PRESS and ON RELEASE.

2 hours ago, richboy2307 said:

Can I suggest setting it to TOGGLE THROTTLE REVERSE THRUST instead for this function? If its a button you intend to use while its held, set it to toggle both ON PRESS and ON RELEASE.

That basically works BUT

Owners of throttle quadrants (HC Bravo etc) probably like to have toggles for each engine and applying (reverse-) thrust with each lever separately.
Should not be a biggy, since the commands are already there ...

7 hours ago, JetNoise said:

Owners of throttle quadrants (HC Bravo etc) probably like to have toggles for each engine and applying (reverse-) thrust with each lever separately.

I have a Honeycomb Bravo, and I do prefer to be able to have independent reverse thrust settings for each lever. Unfortunately, as of yet, I haven't been able to find a way to set up a reverse thrust toggle input that works at all in SPAD.next, even for all three levers at once. The bindings that usually work with other aircraft simply don't work with the TriStar. I've had similar problems with a couple of other iniBuilds aircraft, where the thrust reversers and a few other controls only work using MSFS' built-in bindings and can't be made to work using any of the common bindings in SPAD.next. Super annoying, because I'd love to be able to make all the controls work exclusively through SPAD, but iniBuilds apparently doesn't allow that at the moment.

Edited 1 hour ago1 hr by zbrainlezz