Throttles at idle vibrating into reverse

[MediumRareBaku]

I am using the Honeycomb Bravo.

I've calibrated my throttles in the EFB. Idle calibrated to idle, etc., but no matter how many times I calibrate them, once my Bravo levers are at idle, the throttles in the sim sit there and vibrate between idle and the beginning of the reverse range, and sometimes vibrate enough into reverse that the reversers unlock.

I do not have any reverse bindings set in the sim and I do not have reverse on the axis set to on.

I am not using the 0-100 axis option per the manual. 

[Squatchpilot]

I have noticed this as well. 
 

I will say, I’m not a fan of how the reverse is modeled in this bird…the reverse doors should be fully open before any power is applied…however this is not the case..they open further the more reverse throttle you pull in.

Inibuilds….can we fix this to open the reverse doors fully the moment reverse thrust is selected? 

[IniJamir]

1 hour ago, Squatchpilot said:

I have noticed this as well. 
 

I will say, I’m not a fan of how the reverse is modeled in this bird…the reverse doors should be fully open before any power is applied…however this is not the case..they open further the more reverse throttle you pull in.

Inibuilds….can we fix this to open the reverse doors fully the moment reverse thrust is selected? 

Hi,

Did you verify that you updated to v1.0.1 as this was listed as fixed in the changelog for Tuesday's update. If it is still occurring please make a new post with media attached please and thank you.

On 4/3/2026 at 7:08 PM, MediumRareBaku said:

I am using the Honeycomb Bravo.

I've calibrated my throttles in the EFB. Idle calibrated to idle, etc., but no matter how many times I calibrate them, once my Bravo levers are at idle, the throttles in the sim sit there and vibrate between idle and the beginning of the reverse range, and sometimes vibrate enough into reverse that the reversers unlock.

I do not have any reverse bindings set in the sim and I do not have reverse on the axis set to on.

I am not using the 0-100 axis option per the manual. 

I've passed it along to the team as well. Thank you

[Squatchpilot]

Out of town right now so can’t do a video yet but yes, I’m updated successfully (other fixes seen) but the reverse is the same