Daneng Posted November 21, 2022 Share Posted November 21, 2022 After entering the correct ADF frequentie , the needle on the ADF RMI does not move . Can anybody confirm if the ADF is working ?? Thank you in advance. Dan. Link to comment Share on other sites More sharing options...
Alexair Posted November 21, 2022 Share Posted November 21, 2022 Just gave it a try, on my side both ADF are working fine. Be sure to check that the light toward the ADF frequencey is light (I mean check that you switch the freq. side to the correct ADF). Then below the EVSI the needles are working just fine. 1 Link to comment Share on other sites More sharing options...
Daneng Posted November 21, 2022 Author Share Posted November 21, 2022 Ok checked as you said and working OK now . Thank you so much and Best regards Dan. 1 Link to comment Share on other sites More sharing options...
Recommended Posts