Strangest thing, the aircraft will not taxi (move) after pushback.  I use the GSX pushback tool with no issues.  However, the aircraft will not taxi/move.  The parking brake is released (confirmed).  The brake system is in normal/on.  I do note that the brake pressure reads zero with the parking brake off and in the normal range when set.  

I'm using the TM Boeing Throttle for the 737 which I've configured and verified the engines (forward/reverse) functions.  I can toggle the parking brake with a preset button in the TCA (737).  I've uninstalled and re-installed the aircraft via content manager with no luck. 

Any suggestions or configuration check are appreciated.  

Thank you.

Heya,

can you please try with the native pushback and see if you still have the issue, then report back?

Thank you!

Thanks for the reply.

 I tried the native pushback.  Same issues with native pushback.  

Would it have anything to do with the Shadow Maps?  I did modified this setting per the guidance in the INI manual to 2048.

Thank you.

In that case please make sure that there is no button, slider or whatever else bound to a brake command.

 

I do not think it has anything to do with shadow maps, no.

Also maybe send me a screenshot of your brake pedals please.

Thanks again for the response.  

I've attached the screen shots you requested.  I had planned to remove the brake bindings after engine start with the power up.  As soon as I released the parking brake, the aircraft started to roll.  I then moved aircraft and moved airports from LEIB to EGCC.  The aircraft responded to the brakes off and throttle movement and keyboard braking.  

Perhaps it was the PC restart that helped correct the issue.  

Thanks again for the support. 

No problem at all 🙂

Glad the issue is gone now, if it arises again, please open up a new thread as I will lock this one.