Good evening.

I just experienced a new bug concerning the ECAM which I think was NOT present on older versions:

On the real Aircraft, when you are on an ECAM system page (for exampe Fuel) and press the key for THIS system page again on the ECAM control panel (so yes, a second push on "fuel"), you return from the system page to the basic ECAM page (on ground: Doors / in flight: Cruise). I think this worked on older versions and for sure works like this on the A350 (just checked it).

Now you have to press the ECAM pushbutton several times, to return to the "basic" page.

I hope you understand my problem and have look at it... 😄

regards,

Benni Thill

On 6/3/2026 at 1:51 AM, BenniT. said:

Good evening.

I just experienced a new bug concerning the ECAM which I think was NOT present on older versions:

On the real Aircraft, when you are on an ECAM system page (for exampe Fuel) and press the key for THIS system page again on the ECAM control panel (so yes, a second push on "fuel"), you return from the system page to the basic ECAM page (on ground: Doors / in flight: Cruise). I think this worked on older versions and for sure works like this on the A350 (just checked it).

Now you have to press the ECAM pushbutton several times, to return to the "basic" page.

I hope you understand my problem and have look at it... 😄

regards,

Benni Thill Geometry Dash

I can reproduce that behavior as well. If a second press on the same ECAM page used to return directly to the default page, then it does sound like a regression rather than an intended change.

Edited Tuesday at 08:28 AM2 days by nesaseka2430

Can either of you get a video for me of this occurring? Either YT link or Google Drive link is fine. I think I recall experiencing this myself and will try to get it recorded myself if not possible. Thank you