1. Load the aircraft, cold and dark
2. Enter the cockpit, swap to FE station, observe cabin altitude gauge
3. Needle starts full scale high climb, moves to full scale low descent, stays there.
4. Opening doors, turning on power, turning on the APU and a pack doesn't change it.

I uninstalled -- including deleting the WASM folder -- and reinstalled and the behavior is still present. I did not have the aircraft selected in the menu when doing so.

Thanks team is working on pressurisation system/controller related issues.

I know 1.0.5 was supposed to cure the pneumatic system, but I am still seeing the cabin climb gauge start low and move to 0 upon initial load in, and when bringing the APU bleed and Pack 2 online there is a 500-1000fpm descent rate on the cabin climb gauge followed by an oscillating climb/descent pattern that eventually settles on 0.

After takeoff, if you take off with only Pack 2 operating, when you bring the next pack online the cabin moves to full scale descent on the cabin climb gauge, and then it reverts to the previous climb rate. Bringing the 3rd pack on bumps the climb rate down a bit briefly and then it returns. There shouldn't be such a dramatic descent when you bring the 2nd pack online.

Edited 4 hours ago4 hr by MediumRareBaku