Hi, 

A couple of times I have encountered hydraulic failures randomly. I do have wear and tear set to realistic. But on this occasion I tried to reset the failures mid-flight as I couldn't be bothered with returning to my departure airport, but I couldn't do so. I then reluctantly landed back at my departure airport and shut the plane down and serviced the hydraulics hoping it would be cleared. I then restarted the engines and the faults were still present. Can Inibuilds advise if I can remove failures or at least cancel them?

Thanks

Hi @PotatoSalad

Perhaps try to clear all the contents of the folder listed below, as that will help reset the maintenance status of your A300. This should resolve any conflict caused by some status mismatch during an update.

*Do note it may reset some options on the EFB, including your throttle calibration so you will need to set those again.

MSFS Steam Edition:

Quote

%APPDATA%\Microsoft Flight Simulator\Packages\inibuilds-aircraft-a300-600

MSFS MS Store Version:

Quote

%LOCALAPPDATA%\Packages\Microsoft.FlightSimulator_8wekyb3d8bbwe\LocalState\Packages\inibuilds-aircraft-a300-600

Thanks!