Hi, previously tried on the inibuilds/ASOBO A310 to set the visible pilots in the models config, it created a problem that caused the knobs and buttons not working (cannot be clicked), and now the same issue happens here, in the A300 (tried in freighter version). Why this happens? What nodes must I set after the last ones? 

Do you not allow to set visible pilots in the cockpit? 😞

 

I do not follow, there should be visible pilots in the cockpit when in outside cam without changing any files

Its meant from the inside of the cockpit, the common method to make the pilots visible there is to copy in the models section the pilot_1 and pilot_2 parts from LOD01 to LOD00 and add two nodes numbers. It works for most aircraft, asobo and third party. And this creates the issue described in the first post

Quote

 

Here I recorded the issue in the cockpit when visible pilots are working: 

 

Exactly the same behaviour in the A310 in MSFS from inibuilds. 

And here is the tutorial I followed: 

 

I have found the solution, you can close the topic. 

5 hours ago, bmaising said:

I have found the solution, you can close the topic. 

Would you mind sharing the solution for other people who run into the issue?

Hi,

Can you share the solution as I have this same issue as well. Both pilots in the cockpit in both variants.