SkyKlop

Attached is a pdf of all my VelocityOneFlightStick mappings. Some are mine but most are the defaults of which I haven't tested yet. I haven't really paid much attention to the collective response. IMO, it seems like the it is not very responsive to dropping the speed and altitude very fast. Not sure if you have to go to idle or lockout to land or there is some other trick. Hunter Helicopter-Velocity1Flightstick.pdf

Agree, this would be quite helpful.

FYI, I was finally able to map the Throttle Lever using Spad.NeXt to my Velocity One FlightStick. There appears to be no way to map it without doing LVAR commands.

Questions 1. How to determine if governor is engaged. What display? 2.how to change. AP speed to 0 knots, won’t take 0 input. I’m having difficulty landing and slow down 3. How do I make incremental changes to heading, bearing when using auto pilot. Should be able to use Bravo Quadrant knobs to make slight adjustments rather than having to do three steps, select menu item, use keyboard to type in value, select menu item again. 4. how do I quickly disable AP speed? 5. how do I remove Mission Control instructions overlay after refuel and repair? It is covering up targets 6. See Kwikflight Hunter Throttle Axis for issues with throttle level settings

Same problem with me. Only tried in MsFs 2024, The manual doesn’t make sense. There is no Master Throttle control setting in 2024. Nothing but the mouse can move that throttle level to OFF, Idle, Fly, and Lockout. Can this only be done with SPAD.NEXT or Axis and OHs?