vumi101

I had this WASM crash when I clicked the CMPNY WIND REQUEST button on the MCDU. To reproduce Load at gate Power on aircraft (Battery, GPU) Complete MCDU setup (weights, fpl, SIDs and STARS) Click CMPNY WIND REQUEST on INIT Page Orange WASM Crashh on Screens Information Aircraft: A350-900 (version 1.1.8) Simulator: FS24 Navdata Method: NAVIGRAPH OFP: Not required, happens on any route Specs: Intel i7 12700k, RTX 40080 Super, 32GB RAM Autosave: Attached latest .BIN file before crash WASM: Module: /SimObjects/Airplanes/A350/attachments/inibuilds/Function_Interior_A350/panel/inibuilds-A350.wasm Gauge: EFIS wasm crash.txt 1764751760.bin

Noticed in the F-PLN page, the system is adding the runway course to the 360 bearings. So FACT R01 is 11 degrees, and here we see the course being written as 371 degrees (essentially just adding the runnway heading to 360). I am not sure if this is suppose to be like that. Just an FYI.

Same on the SAA ZS-SXF livery.

Can confirm the same issue. It is usually triggered by traffic in the general area, but not close enough to trigger TA/RA. Details Online Network: VATSIM Traffic Injections: FSLTL System: i7 12700k, 32GB RAM, RTX4080 Super Sim: MSFS2024 (SU3)

Can confrim as well. Default Navadata no issues. Latest AIRAC through Navigraph gives me WASM crash after about 3 hours of flight.

Can confrim as well. Default Navadata no issues. Latest AIRAC through Navigraph gives me WASM crash after about 3 hours of flight.

Not sure about the strobe issue, but I think I have figured out the electric 'reset' issue. I had the debug window open to monitor performance and clicking anything in that window causes the electrics and reset. Just a note. Not an isssue.

Just noticed a slight change, strobes are now back. However, the electric system just 'reset' itself for a second and now I have a deployed RAT. Strange, could be a errant keybind on my end. Will monitor. Thanks for the quick response. SU3 installed.

Hi there, Great addition to fleet, I just noticed the strobes are not working. I set them to both AUTO and ON, and no strobes. 🙂

Same here, OIS button does not affect it either.

Thanks so much @Eddie!!

Hi iniBuilds team! I just wanted to find out a release time for your FAOR scenery on the 27th? As part of the IVAO XZ Southern Africa division, we would like to have our ATC controllers online on Friday and possibly Saturday to host pilots in our virtual skies to celebrate the release of your scenery. Thanks in advance!