Sounds
13 topics in this forum
-
Hi, It would be nice if the AMP would work with volume knobs working, ie if turned off no hear and when turned up we hear comensurate to the knob position up to max. I tried several VORs ADFS ILSs and turned the ident ON but we don't hear anything?? Even in the new A340-300, nothing is heard??
-
- 7 replies
- 233 views
- 1 follower
-
-
I have an issue with the sound from the radions dropping out on the A300. I'm flying the PW freighter variant with the IDC enabled. When I use the radio the voices are transmited with intermittend dropouts. I tested this with both BeyondATC and SayIntentions and both come back all chopped up. It's so bad that I miss vital information when listening and only the text box of both programs can fill me in what the transmissions really said.
-
- 3 replies
- 1.3k views
-
-
The Airbus has become even better since the last update—thanks! Unfortunately, I can't say the same about the sound. The enginesound has become very quiet—no matter what settings I use—and I no longer have any trim sound. Has anyone else encountered this, or does anyone have a tip? Thanks and regards.
-
- 0 replies
- 110 views
-
-
As opposed to what today's change log says, these things were not fixed in today's update. They are still absent. This was with a clean install, tested on the PW freighter.
-
-
- 3 replies
- 939 views
-
-
Just did my first flight with the A306. My only issue is the engine sounds are extremely quiet. They seemed fine at idle thrust but then actually got quieter when I set takeoff power. Was using the GE variant and had the interior engine sound slider all the way up. Have seen this issue pop up on a few other forums.
-
-
- 2 replies
- 693 views
- 1 follower
-
-
What I noticed in the A300 is that between the 40 and 30 callout there is always a big "pause" independent of the rate of descent. Even without flaring at all, the time between the 40 and 30 callout is a lot longer than between the other callouts. As you are working on an update, maybe you can put this on the list as well and investigate it.
-
- 0 replies
- 369 views
-
-
Like the title states there is the problem that all cockpit fan and ventilation sounds aren't fading out when moving out of the cockpit with them staying at full volume in the cabin.
-
- 0 replies
- 680 views
- 1 follower
-
-
Please adjust the cockpit sounds so I don't hear them when I am in a saved view. I.E. Wingview from the cabin I can hear the cockpit sounds like they are happening right next to me.
-
- 0 replies
- 539 views
-
-
Compared to the latest version for 2020, there are almost no sounds coming from the nosewheel while taking off. In other words, the plane's landing gear is suspiciously quiet while taking off.
-
-
- 8 replies
- 2.3k views
-
-
With the engine covers on, you can still hear the engines spinning, as if they are open to the wind.
-
- 1 reply
- 783 views
-
-
It appears the rudder trim reset button has no sound right now.
-
-
- 3 replies
- 1.2k views
-
-
When using the default "autopilot on" command, the associated switch doesn't make a sound. However, it will make a clicking sound if one uses the mouse cursor to turn it on.
-
- 0 replies
- 772 views
-
-
The sound for the red AP disconnect button on the yoke has no sound right now.
-
-
- 3 replies
- 1.8k views
-