Luca Fiorini Posted August 29, 2022 Share Posted August 29, 2022 Hello, I have a problem with the A300, I tried to search for solutions but I can't find one. When I have to descend after the T/D I set a lower altitude on the MCP and press the profile button. Everything works fine until the plane reaches the altitude I set in the MCP earlier because it continues to descend below that altitude and I have to disengage the AP and continue in manual. I was wondering if there's a reason for that, maybe I'm doing something wrong, or it's a sort of a bug. Thanks Link to comment Share on other sites More sharing options...
Administrators Sam Posted August 30, 2022 Administrators Share Posted August 30, 2022 Hello Luca, Could you provide a video of this issue? Does the aircraft also go through the selected altitude when using VS for example? Sam Wheeler Senior Management | iniBuildsinibuilds.com Link to comment Share on other sites More sharing options...
Administrators iniBuilds Posted August 30, 2022 Administrators Share Posted August 30, 2022 Link to comment Share on other sites More sharing options...
Luca Fiorini Posted September 3, 2022 Author Share Posted September 3, 2022 On 8/30/2022 at 4:32 AM, Sam said: Hello Luca, Could you provide a video of this issue? Does the aircraft also go through the selected altitude when using VS for example? Hello, the problem seems to be solved. I just re-installed the plane and it works perfectly fine. By the way, thank you! 1 Link to comment Share on other sites More sharing options...
Recommended Posts