Jump to content

Recommended Posts

Posted (edited)

Hello!

I use the honeycomb Bravo Throttle for my flight sim and when I set the gear to down (or up) The airplane immeadletley goes to the off (center) position before it can finish, which is super annoying. Meaning that the gear cant fully extend or retract. Has anyone else had this issue?

Attached is my log.

Kayden

Log.txt

Edited by Inspiration_Aviation
  • Administrators
Posted

Hi there,

Ensure you don't have axis or any other bindings set to the landing gear. With the Bravo throttles, recommend just setting a single key/switch bind for the landing gear.

Posted

I have the Bravo, use gear down and for 'up' use gear toggle. Note you will have to cycle the gear lever twice to the up position, 1st time retracts gear and doors, 2nd time will set it to the center position, it wont lower the gear on the 2nd cycle. Next down selection will lower the gear.

Cant find any way to do this as single up and down.

Posted

I have had the same thing you describe happen on occasion, but not always.  Most of the time the Bravo "gear up" movement brings the handle and the gear up.  If the gear handle does not go to "off" on its own, I set it that way with the mouse.  From "off" to "down" the Bravo is used.  When it works, it works!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...