55 minutes ago55 min Good evening,I was on a normal flight, following the same procedure I usually do,I started Engine 1... and it didn't start. N2 oscillated around 4.5%, while N1 remained at 0%.I tried to restart it by turning the engine off. This time, as I moved the Engine Master switch to the OFF position, N1 climbed to 10%. I moved the Engine Master switch back to the ON position to inject fuel, but nothing happened, as I noticed that the fuel flow was at 0.I switched the left fuel pumps off and back on, and the fuel flow increased to 850 kg/h, but N1, N2, and N3 remained unchanged.I then tried starting Engine 2, but I encountered the same problem.I can confirm that the engine mode selector was in the IGNITION/START position during the start sequence, and that the fuel pumps, APU, and APU bleed were all ON. I even tried switching the PACKs OFF, but it made no difference.I've done more than 150 flights with the A359, and this is the first time I've ever encountered this issue.Thank you in advance Edited 53 minutes ago53 min by Antoine G
29 minutes ago29 min Staff 25 minutes ago, Antoine G said:Good evening,I was on a normal flight, following the same procedure I usually do,I started Engine 1... and it didn't start. N2 oscillated around 4.5%, while N1 remained at 0%.I tried to restart it by turning the engine off. This time, as I moved the Engine Master switch to the OFF position, N1 climbed to 10%. I moved the Engine Master switch back to the ON position to inject fuel, but nothing happened, as I noticed that the fuel flow was at 0.I switched the left fuel pumps off and back on, and the fuel flow increased to 850 kg/h, but N1, N2, and N3 remained unchanged.I then tried starting Engine 2, but I encountered the same problem.I can confirm that the engine mode selector was in the IGNITION/START position during the start sequence, and that the fuel pumps, APU, and APU bleed were all ON. I even tried switching the PACKs OFF, but it made no difference.I've done more than 150 flights with the A359, and this is the first time I've ever encountered this issue.Thank you in advanceHi,I'm not entirely sure what could be causing this. Could you please try on a default or iniBuilds livery?Thanks! Kyle - Community Manager iniBuilds Ltd. | inibuilds.com
Create an account or sign in to comment