GSX Is recognising that stands have jetways, but when they're in operation (as selected through GSX) none of them are animated and remain stationary.
GSX acknowledges they've moved and are in place, but the physical model hasn't moved.

Not sure how many affected, the last stand I just tested was 221L, with no jetway movement.

Scenery is at latest version, with V1.5 of the GSX profile installed.

Multi-jetway tool isn't installed currently as I have no use for it.

7 hours ago, Liamr685 said:

GSX Is recognising that stands have jetways, but when they're in operation (as selected through GSX) none of them are animated and remain stationary.
GSX acknowledges they've moved and are in place, but the physical model hasn't moved.

Not sure how many affected, the last stand I just tested was 221L, with no jetway movement.

Scenery is at latest version, with V1.5 of the GSX profile installed.

Multi-jetway tool isn't installed currently as I have no use for it.

Hi Liam,

Thanks for your feedback. I'll test this in the morning and report back with my findings.

Thanks again!

I can confirm: I connect the two jetways to the A350 via the EFB, but when I start boarding with GSX, it doesn't see them as connected—it reports "bad jetway data."

3 minutes ago, david saotome said:

I can confirm: I connect the two jetways to the A350 via the EFB, but when I start boarding with GSX, it doesn't see them as connected—it reports "bad jetway data."

Hi,

Yes, if you're using our multi-jetway tool with GSX, there is currently a limitation that prevents passengers from appearing. We've reached out to the GSX team in hopes of getting this resolved, but unfortunately, we have yet to hear back.

Thanks for your patience and understanding!

On 8/27/2026 at 1:41 PM, Liamr685 said:

GSX Is recognising that stands have jetways, but when they're in operation (as selected through GSX) none of them are animated and remain stationary.
GSX acknowledges they've moved and are in place, but the physical model hasn't moved.

Not sure how many affected, the last stand I just tested was 221L, with no jetway movement.

Scenery is at latest version, with V1.5 of the GSX profile installed.

Multi-jetway tool isn't installed currently as I have no use for it.

I have the same issue

At the moment, GSX sends a passenger bus and stairs, and in this case passengers running around the apron, I get the feeling it's too soon for multi jetway and gsx, heavy gates will need stairs for the time being