Just recognized, after using the 300 after a longer time, that I'm not be able anymore getting the landing gear lever up and in the middle position. I use HC bravo and I'm flying in 2024, beta 6. The softwarelever stays in down position while the hardwarelever of the HC went up. It vibrates and bumps in that down position as if it tries to go up, but it doesn't can do it. Fortunately in the plane the gears are going up, only the lever in VC doesn't go up. For that reason I'm not able to arm autobreakes. I know it works before; I put the lever in the middle position with the mouse, but for that the lever has to reach the up- position before. What can I do here?

Edited Saturday at 05:07 PM2 days by KaiUweWeiss

Hi,

You said you are on SU6 Beta, it's possible some behavior or unintended change as a result of SU6 could be causing an affect here. I don't have a HC Bravo but I will raise this to the team. Does this occur in current SU5?

15 hours ago, IniJamir said:

Hi,

You said you are on SU6 Beta, it's possible some behavior or unintended change as a result of SU6 could be causing an affect here. I don't have a HC Bravo but I will raise this to the team. Does this occur in current SU5?

I'm not sure if this occured in SU5 too, honestly spoken. It would be fine if the team could have a look at this, thank you.

I'm on SU6 beta and had no issues with it. However one thing I have done a long time ago was to adjust the gear settings in the sim and while this might not apply to the honeycomb, it also might

I have the TCA captains pack the gear lever is a switch. If you look at how it works in control settings, repeat input was turned on for gear up while gear down was the same button but "when released". So this meant that you couldn't set the neutral position as the sim was constantly trying to retract when the physical lever was up. By deselecting the "input repetition" option, it fixed all the landing gear issues I was having. Worth having a look at

Thank you, I will have a look at this.