Reverse Thrust Unbinds Engine 2 Throttle

[JaredGPW]

Hello,

I've been having an issue using the Thrustmaster Boeing quadrant and the throttle bindings. I have engine 1 bound to one throttle lever, and engines 2 and 3 bound to the other. These are assigned to the, "Throttle 1 Axis" on one lever, and "Throttle 2 Axis" and "Throttle 3 Axis" on the other lever. This works just fine for moving the throttles. They all respond as they should. I have reverse thrust bound to, "Hold Throttle Reverse Thrust". When I engage the reverse thrust on the throttle quadrant, only engines 1 and 3 reversers respond. When I disengage reversers and then attempt to move the throttles again, engine 2 seems to be unbound and will no longer respond to movement of the throttle levers. I have to go back into the control settings, switch to another profile, then switch back to my L1011 profile. This seems to reset it and engine 2 will respond correctly with the throttle levers now, but engaging reverse thrust will break it again. I've tried all sorts of binding combinations and can't seem to get this to respond correctly. Any suggestions? 

Thanks,

-Jared