ECAM Handling

[Andrew M]

Has anyone had, or have a fix for, the ECAM handing on the 350? I have a problem where after clearing the initial failed system, each secondary failure page immediately gets 'ticked' off without giving me time to run the procedure correctly. It subsequently speeds through the ECAM procedure until it gets to the status page. 

[Andrew M]

GIF of the issue

 

Additionally, unable to deactivate abnormal ECAM's, therefore leaving incorrect deferred ECAM procedures. 

Edited December 16 by Andrew M

[Andrew M]

Has anyone had similar issue?

[Andrew M]

Also tested on v1.2.0 and the issue still exists.

[silentghostx]

Haven’t had or seen this issue before… have you checked hardware binding? Possibly an issue with a key or a component that’s doing the automatic tick off..? 

[Andrew M]

I've checked hardware binding and confirmed that it's not an issue with the ECAM item being ticked unaware, also demonstrated that activating the item in the Abnormal checklist requires it actively being ticked.

A re-install also has not resolved the problem either.

[silentghostx]

Hmmm not sure what’s going on there with your set up. 
I tried the same ABN checklist on my side, forgot to record at the first few items but here’s mine - seems to be working ok.

 

[Andrew M]

I have found that by mapping a key to the ECAM tick release can prevent the issue, provided the tick release is actuated prior to any checklist. If the release hasn't occurred at least once prior, the issue remains.