Andrew M Posted December 15 Posted December 15 Has anyone had, or have a fix for, the ECAM handing on the 350? I have a problem where after clearing the initial failed system, each secondary failure page immediately gets 'ticked' off without giving me time to run the procedure correctly. It subsequently speeds through the ECAM procedure until it gets to the status page.
Andrew M Posted December 16 Author Posted December 16 (edited) GIF of the issue Additionally, unable to deactivate abnormal ECAM's, therefore leaving incorrect deferred ECAM procedures. Edited December 16 by Andrew M
Andrew M Posted Thursday at 04:16 AM Author Posted Thursday at 04:16 AM Has anyone had similar issue?
Andrew M Posted Friday at 04:52 AM Author Posted Friday at 04:52 AM Also tested on v1.2.0 and the issue still exists.
silentghostx Posted Friday at 12:40 PM Posted Friday at 12:40 PM Haven’t had or seen this issue before… have you checked hardware binding? Possibly an issue with a key or a component that’s doing the automatic tick off..?
Andrew M Posted Saturday at 07:13 AM Author Posted Saturday at 07:13 AM I've checked hardware binding and confirmed that it's not an issue with the ECAM item being ticked unaware, also demonstrated that activating the item in the Abnormal checklist requires it actively being ticked. A re-install also has not resolved the problem either.
silentghostx Posted 2 hours ago Posted 2 hours ago Hmmm not sure what’s going on there with your set up. I tried the same ABN checklist on my side, forgot to record at the first few items but here’s mine - seems to be working ok.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now