Flap linkage clipping into wing

[MediocreGorilla]

Hi everyone,

I've just noticed a little inconsistency I'd like to pass on.

On Flaps full, the inboard linkage on the outboard flaps is clipping through the flap actuator shaft, aswell as the wing's edge. This is especially noticeable during rollout with the spoilers fully extended.

 

I totally understand that your art department probably has absolutely no idea or documentation about where this goddamn rod goes during retraction. 🙂 

I can't tell either, however I've at least found some footage showing that it's actually mounted higher up on the wing than it currently is in sim:

Adjusting this should at least eliminate the clipping.

Maybe you can take a look?

Cheers!