WHY I CANNOT START THE ENGINE

[MATTCNLIVE]

As photo shows, I am confused that I cannot start the engine after I upload to V1.0.5。

[chaser911]

I have the same problem after the update.

And yes i deleted the WASM Folder.

 

[VBHB]

Yep can't start the A350-1000 either after updating and installing fresh livery.

[orisida]

I am also experiencing this issue since the update

[MATTCNLIVE]

1 hour ago, chaser911 said:

I have the same problem after the update.

And yes i deleted the WASM Folder.

 

however i cannot find WASM folder of MSFS2020...

PS:already found the folder under the tutorial link：

Edited March 22 by MATTCNLIVE
found the answer after the reply

[Aiden925]

i have the same problem

[flight851]

Whenever I put the beacon light to on the whole aircraft shuts down.

[MATTCNLIVE]

1 hour ago, Aiden925 said:

i have the same problem

delete all the files in the folder of WASM. the link is in the reply.

[srce]

On 3/22/2025 at 1:54 PM, flight851 said:

Whenever I put the beacon light to on the whole aircraft shuts down.

Do you have the APU running?

[srce]

On 3/22/2025 at 10:49 AM, MATTCNLIVE said:

As photo shows, I am confused that I cannot start the engine after I upload to V1.0.5。

No oil?

Try refilling in OIS maintenance page.

 

[haza2]

On 3/22/2025 at 10:49 AM, MATTCNLIVE said:

As photo shows, I am confused that I cannot start the engine after I upload to V1.0.5。

Is this fixed for you guys?

 

[cmdn]

I can't start the engines since the last update 1.0.6

I have cleared the WASM folder I have reinstalled the plane. Nothing has worked.

[richboy2307]

Hi, this is a very strange issue that we're not able to reproduce for the time being.

For those of you having this issue, please verify the following

• 3rd Party Liveries: Try without any 3rd party liveries in your community folder to rule out any conflicts.
• IniManager Liveries: Ensure you have updated all installed liveries via the iniManager to the latest version
• OIS Maintenance Options: Try to service your APU and Engines. Normally these should reset with an update/WASM folder clearing but try this to rule out any anomalies.
• Assistance Options: Check that AUTOMIXTURE is set to OFF in the sim assistance options.
• Control Bindings: Verify your control bindings and remove bindings related to MIXTURE or FUEL which may be causing conflict. Users of Honeycomb Alpha yokes should also verify no conflicts being caused by their hardware ignition switches over-riding sim functions.
• Clear WASM folder: As suggested above already, if you haven't already please try to clear your WASM folder by following the instructions here: 

In case none of the above resolve your issue, please share a custom save file (.bin) of your situation with us so we can try on our end. Please see below guide on how to create and share custom saves:

Thanks!