350 cockpit has some incorrect modeling

[SALMI]

If there is a big disappointment with the cockpit modeling, it seems that the gap between the windshield center object and the upper and lower height gap are significantly different than the RW350

[LineDX]

I think ini did pretty good model. I dont see a need to change that. My 2 cents 

[SALMI]

8 hours ago, LineDX said:

I think ini did pretty good model. I dont see a need to change that. My 2 cents 

I respect what you think but I think it needs to be change

[Swisspilot1986]

Salmi, do you have any technical plans with measurements? Only with pictures it's difficuilt to compare what and how many to change. 

[SALMI]

7 minutes ago, Swisspilot1986 said:

Salmi, do you have any technical plans with measurements? Only with pictures it's difficuilt to compare what and how many to change. 

As far as I know, there are real world A350 pilots helping with the development of iniBuilds so the exact measurement for this depends on iniBuilds' efforts I'm just giving feedback

But what's certain is that some of the current iniBuilds 350 cockpit geometry is different from the real thing

[Atul]

I'm fully supportive of inibuilds but I do agree with Salmi in this case. The proportion feels a little bit larger than the real world counterpart and the windshield divider narrower. Had this perception going since developer streams and post release too. Again, my personal perception. 

Edited Wednesday at 02:03 PM by Atul

[tp09]

And this trim piece too. I bought it up once and got a “different perspectives” response. It’s very disappointing that they got all these cabin models but minimal details to attention on flight deck, which you spend 99% of your time.

 

Edited 26 minutes ago by tp09