Rudder controll tiller issue

[Thomkri1905]

Im using saitek rudder pedals to kontroll tiller.

When i move the rudder pedals to a certain degree the plane starts turning the opposite direction. 

Any know what causes this or know how to fix it?

[srce]

I've seen this. But previously I had noticed a red message pop at the top of the screen saying "gear damaged" or something similar during push back, so might have been related to that. Not sure why the gear should have been damaged...

[pertadon]

I have the same issue. Rudder controls tiller is on, tiller is turning, nose wheel is turning.

However when I increase the throttle a little bit to get the aircraft going and I input full tiller to any direction, the aircraft seems to start turning in that direction but shortly after it turns to the completely opposite direction.

Regarding what srce said, I get the same red message that the gear is damaged when I pushback via GSX and I have the nose wheel lift option on. So this might be what causes the issue. 

When I pushback with a towbar without nose lifting, the message doesn't appear and the airplane steers normally.

The workaround I see right now is to disable pushbackRaise option in GSX Menu > Customize Aircraft, however this setting is not persisted and will be turned back on every new flight.

 

[Martin5042]

I have experienced the same problem where I am unable to turn the plane and also received a message saying ‘gear damaged’

[Thomkri1905]

1 hour ago, pertadon said:

I have the same issue. Rudder controls tiller is on, tiller is turning, nose wheel is turning.

However when I increase the throttle a little bit to get the aircraft going and I input full tiller to any direction, the aircraft seems to start turning in that direction but shortly after it turns to the completely opposite direction.

Regarding what srce said, I get the same red message that the gear is damaged when I pushback via GSX and I have the nose wheel lift option on. So this might be what causes the issue. 

When I pushback with a towbar without nose lifting, the message doesn't appear and the airplane steers normally.

The workaround I see right now is to disable pushbackRaise option in GSX Menu > Customize Aircraft, however this setting is not persisted and will be turned back on every new flight.

 

Thanks. I will try disabling pushbackRaise

[srce]

I'm not sure it is that setting. I tried 3 additional pushbacks with out it, and I didn't have the gear failure again.

[pertadon]

1 hour ago, srce said:

I'm not sure it is that setting. I tried 3 additional pushbacks with out it, and I didn't have the gear failure again.

It depends if the operator has a tug that lifts the aircraft or not. If a tug with a towbar spawns it won't lift the aircraft even if the option is on, and the gear failure won't happen, but if you select an operator with a lifting tug the gear always fails, at least on my part.

[srce]

I notice there's also a tyres damaged message.

On the OIS under maintainance you can replace tyres, but that doesn't help.

 

[Platypus]

same issue here with GSX and nose lifting pushback

Edited February 28 by Platypus