richboy2307 Posted December 10 Posted December 10 The Transponder and TCAS modes are switched via the ATC/TCAS CONTROL page of the IDC. To access this page, press TUN > LSK L5 on the ATC1 code. To set the Transponder Code (XPDR), use the numpad to enter the desired squawk code into the scratchpad, then press LSK L1 to enter it into the ATC1 field. To SQWK IDENT press LSK L2 when the active TCAS mode is TA/RA or ALT ON. It will flash dark grey/white when successful. To change the TCAS RANGE between 6nm and 12nm respectively, press LSK L4. The active value will be highlighted in blue. To enable/disable TRAFFIC display on TCAS, press LSK L6 to toggle ON or OFF. The active value will be highlighted in blue. To change the active TCAS MODE, press LSK R1 repeatedly to cycle between STBY, TA/, TA/RA, ALT ON, ALT OFF modes. The active value will be highlighted in blue. To run the TCAS TEST, press LSK R2. It will turn dark grey to indicate the test is active. It will return to white when complete. To run an extended TCAS test, press LSK R3 to toggle ON. Then press LSK R2 to run relevant test. To switch TCAS ALT LIMITS press LSK R4, R5 or R6 for ABOVE, NORM or BELOW modes respectively. For more information on IDC Operation and how to log-on to to the Hoppie Network, please see the linked video below: Vrishabh Sehgal ( @Richboy2307 ) Community Team Member & Tester IniBuilds Ltd. | inibuilds.com
Recommended Posts