Hi
I can't get the autothrottle into the reverse anymore. The value of my throttleaxis in the calibration is at 0 and the "MAX REV" is at the bottom. All other detents works correctly but not the reverse. I tried the tip from the FAQ to switch between yes and no reverse on axis but that didn't help.

I have the thrustmaster airbus throttle quadrant. The axis are well calibrated outside of MSFS and shown correctly in the EFB.

The throttle are binded to "Trottle 1 Axis (0-100%)" ,"Trottle 2 Axis (0-100%)" and so on. Sensitivity is all linear at standard.

What am I doing wrong here?

Best regards

Same issue here. Tried both throttle axis 0-100 and throttle axis. No difference. I am also using the A320 throttle.

Please check the ThrottleData.ini file (open with Notepad). Check for specifically

[throttle]

reverse_on_axis = true

If it says false, change it to true as above. Reverse thrust should then work after a sim restart.

-------------------------------

The ThrottleData.ini file can be found in the respective aircraft's work folder at the following paths.

For e.g. the A400M's work folder will be inside ...\microsoft-aircraft-a400m\work at the below paths:

FS24 Work Folder Paths

Steam:

%APPDATA%\Microsoft Flight Simulator 2024\WASM\MSFS2024\

MS Store:

%LOCALAPPDATA%\Packages\Microsoft.Limitless_8wekyb3d8bbwe\LocalState\WASM\MSFS2024\

 

 

 

Thanks, changing the value on the .ini file worked.

For me too. Thanks!!

Is there a fix for this on the new 2020 release? i cannot find it 

MSFS 2020 - A400M Inibuild: The thrustmaster calibrating procedure is the same as for MSFS2024 and you can easily find videos on Youtube.

The throttledata.ini is located at: 

C:\Users\yourname\AppData\Local\Packages\Microsoft.FlightSimulator_8wekyb3d8bbwe\LocalState\packages\inibuilds-aircraft-a300-600\work 

 

Same procedure as for MSFS2024; set to "true"and the reverse should work.

Edited March 25Mar 25 by MarcoErre