Hello,

I'm still on the ground using Ground Power setting up the plane for the flight when the FMC get's completly frozen. This has happened twice now after a fresh clean install of the plane

Same happened to me with the route here -> 

 

1 hour ago, Genista said:

Same happened to me with the route here -> 

 

My FMC looks exactly like your left side FMC in the picture. I can't fly the plane cause it will freeze and I cant do anything else with the FMC

Edited January 5, 20242 yr by Badam3co

1 hour ago, Badam3co said:

Hello,

I'm still on the ground using Ground Power setting up the plane for the flight when the FMC get's completly frozen. This has happened twice now after a fresh clean install of the plane

Did you enter in a route yet before it froze?  What route?

Edited January 5, 20242 yr by ual763

Should be fixed with 1.0.2
Please test again and report back!

Hi Nico,

 

this exact fault happened to me the first time at all just after i updateted to 1.02. It happened in the moment i entered the ZFW in the InitB Page.

 

Daniel

 

Just had this problem after installing the new update. When I try to put in the ZFWCG in the INIT B page, the FMC freezes and all click spots on the aircraft do nothing. I was at KMEM when this happened. 

I think I know what happened.:
Block Fuel in the W&B page was incorrectly set (I have it set to imperial - this is an IniBuilds EFB issue) KG while the fuel figure where you put the load was correctly set to LBS. However, I tried putting in the KG figure. I believe when I set the ZFWCG and the aircraft made all of its calculations, it panicked when it saw the incorrect and small KG figure and froze the whole airplane. 

ual763... you nailed it!!! 👍 Weight and Bal setup first then proceed to Route set (SID / STARS)