CPT Yoke trim jumpy

[Crabby]

I cannot seem to get this smoothed out in the A300.  This Axis and Ohs assignment works like a charm in the A310 (obviously with the LVar for the A310).  In the A300 the trim, when held, jumps in large increments up or down.  It should, "roll", up or down smoothly when held and make little movements when pressed and released.   Any ideas?

[Crabby]

LOL, forest and trees.  I have not tried changing FAST/MED or Slow in the repeat area.  However, this is exactly how I have it set for the A310 and no problems.  Besides any suggestions, I will play with the repeat speeds and see what happens. 

[Crabby]

Well, the trim is jumpy no matter what speed I use for repeat.  

[Helibrewer]

I just use the MSFS ELEV_TRIM_DN and ELEV_TRIM_UP variables. I don't use "Key Up" only "Key Down"

Edited December 29, 2023 by Helibrewer

[Deleted Account]

Let me know if that works for you Crabby or if we need to look into this, thanks 🙂

[Crabby]

I will try this in the morning!  Thanks @Helibrewer and @Nico - Gumby

[Crabby]

@Nico - Gumby @Helibrewer  That worked!  Thanks.