MD82 Posted May 19, 2023 Posted May 19, 2023 Hello, tuning an NDB frequency in the panel to an in-range frequency and the RMI needle cycles back and forth between OFF (horizontal) and towards the station with a frequency of 1 Hz. Arrow never fully points to the station. 1
Deleted Account Posted May 19, 2023 Posted May 19, 2023 Heya! I'm assuming you're on the ground when seeing this behaviour?
MD82 Posted May 20, 2023 Author Posted May 20, 2023 Hello! Negative, airborne at FL380. It's been happening a few weeks for me. In yesterday's example, NDB frequency 376 tuned in (ZIN) at waypoint JOSES to overhead ZIN and towards Miami. It cycled the whole way until I was out of NDB coverage. Cheers ...
Deleted Account Posted May 20, 2023 Posted May 20, 2023 I just flew past it no issues. However I did notice some jittering when being farther away from it, even though it wasn't at the speed you mention. I'm not 100% sure if this is a sim or plane issue though; I'll put it on our internal list for investigation. adfrmi2.mp4 1
MD82 Posted May 27, 2023 Author Posted May 27, 2023 Ok, thanks. Must be me then. It does it with ALL NDB stations 😞
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now