sunny Posted January 15, 2023 Posted January 15, 2023 Hello everyone, how can I control the aircraft after the A310 runs out of fuel? The entire plane lost control and crashed after the engine stalled.
FelixM Posted January 15, 2023 Posted January 15, 2023 (edited) Hi, Land ASAP 😉 1. RAT : On (Ram Air Turbine, there is a handle on the left side of the Captain seats) RAT will allow the yellow hydraulic system to be powered and will give you flight controls to operate. 2. Throttles: IDLE Optimum Speed: green dot speed (average rate of descent 1700 ft/min) 3. Emer Exit LT : Disarm 4. Flaps 15° for approach 5. At 2000 ft AGL Emer Exit LT On 6. Before "impact" Ram Air on, Pitch approx 11° 7. at Touchdown: fuel levers off, pull all fire handles I took the relevant steps from the QRH (Quick Reference Handbook for Both Engine Flame Out Scenario with no Fuel remaining). I listed not all steps, just the most important. Most important thing to to do is to turn on RAT to power the yellow hydraulic system. Hope the helps. Best regards Felix Edited January 15, 2023 by FelixM 1 ---------------------------------- AMD Ryzen 7 7800X3D Nvidia GeForce RTX 4080 32 GB RAM Dell Alienware AW3432DWF 3440 x1440 165 Hz
sunny Posted January 16, 2023 Author Posted January 16, 2023 (edited) 12 hours ago, FelixM said: 你好, 盡快著陸😉 1. RAT : On (Ram Air Turbine, 機長座椅左側有把手) RAT 將為黃色液壓系統提供動力,並為您提供飛行控制以進行操作。 2.節氣門:怠速 最佳速度:綠點速度(平均下降率 1700 英尺/分鐘) 3. Emer Exit LT : 解除武裝 4. 襟翼 15° 進近 5. 在 2000 英尺 AGL Emer Exit LT On 6. 在“衝擊”沖壓空氣之前,俯仰約 11° 7. 著陸時:關閉燃料桿,拉動所有點火手柄 我從 QRH(沒有燃料剩餘的發動機熄火場景快速參考手冊)中採取了相關步驟。我沒有列出所有步驟,只列出了最重要的步驟。最重要的是打開 RAT 為黃色液壓系統供電。 希望有所幫助。最好的祝福 菲利克斯 Where is this handle? I can not find it Edited January 16, 2023 by sunny
Deleted Account Posted January 16, 2023 Posted January 16, 2023 Left side of the cockpit. The red and grey handle 🙂 1
sunny Posted January 17, 2023 Author Posted January 17, 2023 11 hours ago, gumbyger said: Left side of the cockpit. The red and grey handle 🙂 Thank you very much, this problem has troubled me for a long time, and finally solved it。 1
Recommended Posts