ZeeMan90

The cable and EXT PWR logic is still incorrect in v1.1.4. AVAIL should only illuminate once the cables are plugged in. If they are out there should be no AVAIL light.

Still persists in version 1.0.14. Sadly iniBuilds doesn't seem to care about this issue.

The issue still persists in version 1.0.11 for both MSFS 2020 and 2024.

Even in 1.0.11 if a jetway is connected to the plane and 1L door is open (flight deck door closed) you can still hear the APU prominently. This cannot be right as there are approx. 60 meters between the cockpit and the APU exhaust.

Hello fellow A350 enthusiasts, an hour ago I have installed v1.0.9. The changelog states the the APU sound issue has been fixed. However, the APU still can be heard prominently inside the cockpit even with the cockpit door closed.

The issue has been partially resolved. While the sounds of the buttons are now correct again, the cable and EXT PWR logic is still incorrect in v1.0.9.

Dear iniBuilds team, thank you for your tireless efforts in improving the A350 with each version. But as we know, every improvement can cause new hiccups. I came across some minor ones today. In v1.0.8 I have noticed that when EXT1 and EXT2 on the OVHD PNL say "AVAIL" the GPU is not connected to the plane via cables in the external view. Once you press both buttons and they are ON, only then the cables are connected to the plane. "AVAIL" in green should only be lit up, if the GPU is connected to the plane which then indicates that external power is in fact AVAILable to the plane via the cable connection. 🙂 Additionally I have noticed, that both EXT1 and EXT2 buttons have no sounds since v1.0.8 I hope that these issues will be fixed in the upcoming version. I wish you all pleasant Eastern holidays. Best regards

The APU sound in 1.0.8 is too loud. You can hear the APU from the cockpit as if it is not in the rear of the plane. Regards