DroneSim

Simple, you are over 3000ft above the descend profile. The aircraft is already at maximum managed speed range. So it tries to pitch up. Then it remembers that it's still high on profile and pitches down again. That's my guess. I would use open descent in this case.

Btw, in 2024 I don’t use the navdata in the Navigraph hub. You only need to update the navdata in your A350. Maybe you are doing both? another thing I just remembered is that you might be using the wrong SimBrief profile for the aircraft. Which one are you using?

What did I say? 😉😉

I can only think of a navdata issue

My guess is today or tomorrow, but I could be wrong. Last week we got an update Friday (even past EOB)

I can confirm the same issue, but only in MSFS 2024.

The iniManager mixing stuff has to do with your community folder path in the iniManager settings. I can't think of something else causing this. Check your settings and make sure that you put two different folders for 2020 and 2024

Marketplaces in general do need to review stuff before releasing them. Try to publish an app on the Apple AppStore. Reviews take time. I'm sure it will come soon.

Do you get a successful notification message if you select the airport and hit NOTIFY?

I tried a couple of things. To actually get the ATIS/METAR try out the following Make sure your IRS is aligned (Precondition 1 for a successful connection) Make sure to have a Flight Number, DEP Airport, and ARR Airport (INIT PAGE) (Precondition 2 for a successful connection) Make sure you have entered the correct Hoppie ACARS Code in the OIT (Precondition 3 for a successful connection) On the ATC COM -> CONNECT Page, select the Airport which you want an ATIS/METAR from Click on NOTIFY -> you should get a green message "Notified to <AIRPORT> at hhmmZ" indicating a successful connection Now to the D-ATIS page, select DEP, ARR, or NONE and SEND REQUEST This should give you what you want.

You can just load the A350 without a cabin in MSFS 2024. No need to deactivate anything. Just select the No Cabin Model from your aircraft selection

There is a button VIEW OFFSET, left to the OIT. This need to be OFF (not illuminating). Then the options will show up

What do you mean with NI AI is on?

The cursor disappearing is intended. You need to enter the data with the keyboard of the KCCU or click the right control button and type with your real keyboard

Are you on SU1 Beta?

What I observed is that you will get the METAR if there is no ATIS available

I noticed this issue with a lot of other aircraft. I’m not sure if it’s directly related to the A350.

Did you check if the correct ILS frequency/identifier is set in the RAD NAV page?

You need to confirm entries explicitly with the ENTER button 🙂

Your EFB boot time might be set to “realistic”. If so, it takes about 5 minutes to boot

Is your Flight Director on? 🙂

I wouldn't say stupid. The thing is, on the FBW A380, which has similar systems, the scroll bar works with click & hold. So it is not obvious when switching to the A350 🙂

You need to use the arrow UP/DOWN buttons on the KCCU or the scroll wheel 🙂

https://flightsim.to/file/89379/4k-air-india-inibuilds-a350-900-vt-jra

TBH, I noticed a similar behaviour in the iniBuilds A330s. I'm not sure, but I think it's rather related to the FS24 rather than the aircraft itself. Wait, did I say iniBuilds A330, damn 🤣