Hello,

After updating to A380 v1.0.3 on MSFS2024 SU7, I noticed an issue with the ILS display. When flying into KDFW runway 18R, the aircraft correctly follows the glide slope with AP1+AP2 engaged, and the system shows LAND 3 DUAL BARO. However, the glide slope diamond does not appear on the PFD, even though the aircraft is descending along the correct path.

Before the 1.0.3 update, the glide slope indicator displayed normally. Now, only the backup instruments show the glide slope, while the PFD remains blank.

Steps I followed:

- NAV1/NAV2 tuned to 110.95, course 183°

- LS button pressed

- AP1 + AP2 engaged

- Aircraft captures LOC and follows glide slope correctly

Could you please confirm if this is a known issue, or if there is a workaround?

Thank you!

AND I was not flying the FMC route. I used SayIntentions ATC which gave me HDG vectors. Even with heading mode, the aircraft captured and followed the glide slope correctly, but the PFD still did not show the glide slope diamond.

Same problem in V1.0.4

Hi,

Thanks for your report. Is it only happening at DFW?

I tested at JFK and KORD, both are normal At DFW the issue happens, so it seems specific to DFW at the moment. I was using the iniBuilds DFW scenery.

1 minute ago, LIU YU said:

I tested at JFK and KORD, both are normal At DFW the issue happens, so it seems specific to DFW at the moment. I was using the iniBuilds DFW scenery.

Thank you, will note for the team!

Hey Guys, I´ve got the same Problem in the morning on V1.0.4 (SU7) EDDM - Munich

Even if i change the approach runway or type the frequency in manually no ILS Glideslope is displayed.

Thanks for help !

5 hours ago, Christian Schultke said:

Hey Guys, I´ve got the same Problem in the morning on V1.0.4 (SU7) EDDM - Munich

Even if i change the approach runway or type the frequency in manually no ILS Glideslope is displayed.

Thanks for help !

Thanks. I will log this for the team to review. If you notice it at any other airports, please let me know!

So far we have KDFW and EDDM