Whenever I select a different page on the SD I get the R INR TK AFT PMP FAULT message on the E/WD and yes when I check the overhead the pump is off.

Any idea why this would be happeneing?

10 minutes ago, balus said:

Whenever I select a different page on the SD I get the R INR TK AFT PMP FAULT message on the E/WD and yes when I check the overhead the pump is off.

Any idea why this would be happeneing?

Did you turn the pump off because of the fault message or was it already off?

1 minute ago, sultan.of.swing said:

Did you turn the pump off because of the fault message or was it already off?

All pumps were on before I selected the different page on the SD - as soon as the new page is displayed the pump turns off and the message appears. Turning the pump back on via the overhead clears the message.

Hi,

Wondering if there is a keybind issue somewhere. I have not heard or seen any other reports of this behaviour.

If you're able, could you please attach a short video showing this happen?

Thanks!

8 hours ago, iniKyle said:

Hi,

Wondering if there is a keybind issue somewhere. I have not heard or seen any other reports of this behaviour.

If you're able, could you please attach a short video showing this happen?

Thanks!

I doubt it's a keybind as I am only using mouse clicks, not keys or buttons. I'll see how it goes with flight number 2...

59 minutes ago, balus said:

I doubt it's a keybind as I am only using mouse clicks, not keys or buttons. I'll see how it goes with flight number 2...

Just starting flight #2 and it is reproducible. Engines not started, external power connected, APU starting, select ENG page and the pump goes off - turn it back on, select any other page, same outcome, the pump goes off.

EDIT: Even selecting T/O CONFIG turns the pump off, basically any button on that panel will turn the pump off. Mouse clicks on any other location seem to work fine.

Edited 1 hour ago1 hr by balus