Hello,

Since a few days now I am unable to fly the A220 because of the fact that the rudder trim seem to be malfunction.

During the preflight setup it is trimmed green in the center but then the green marker turns white/grey and moves to the right.

The result is that the plane during takeoff turns to the right and is out of control.

Is there someone else with this problem and maybe even with a solution ?

Grtz

Peter

Here’s what I see: while the engines are off, everything is fine with the trimmer. After starting the engines —  normal? Does it start to deviate during the takeoff run? When you increase the throttle, the trimmer deviates. It looks very much like a dual function of the keys.

Edited yesterday at 11:00 AM1 day by Alex711

3 hours ago, PMH1911 said:

Hello,

Since a few days now I am unable to fly the A220 because of the fact that the rudder trim seem to be malfunction.

During the preflight setup it is trimmed green in the center but then the green marker turns white/grey and moves to the right.

The result is that the plane during takeoff turns to the right and is out of control.

Is there someone else with this problem and maybe even with a solution ?

Grtz

Peter

Hi Peter,

This sounds like a keybind issue/conflict. Can you verify that your controls didn't get reset with SU6?

Thanks!

I just found out that the buttons that I use to communicate with copilot and crew in Sayintentions on my yoke suddenly have become rudder trim buttons again.

As you said, most likely with the SU6 update, because I unbound them from the rudder trim a long time ago.

So you were right!!!

I can fly the A220 again without any problem !!

Thanks for your time !!!!

Greetings

Peter