Incorrect elevator trim behavior after touch down. (1.2.3 and 1.2.4)

[nyaru]

For doing local pattern (touch and go), the elevator trim should go to 0 after touch down as version before 1.2.1 did.

After update 1.2.3 (and persisting in 1.2.4) the trim locks on up position which cause floating when TOGA in low speed.

Current workaround:

You have to manual trim it.

[IniJamir]

6 hours ago, nyaru said:

For doing local pattern (touch and go), the elevator trim should go to 0 after touch down as version before 1.2.1 did.

After update 1.2.3 (and persisting in 1.2.4) the trim locks on up position which cause floating when TOGA in low speed.

Current workaround:

You have to manual trim it.

Hi this is a known issue that has been logged, thank you.

[nyaru]

Hi After 1.2.5 this still not fixed.

After touchdown, the pitch trim should:

1. During a touch and go, the pitch trim will automatically move to the takeoff position, based on the aircraft CG.

2. After landing, the pitch trim will move to 0,8° (maintenance position) when the speed goes below 30 kt.

Currently, in both case the pitch trim stays UP 7.0 deg.