A400 Pitch Trim uncontrolable

[zwackelpeter]

Hi guys!

First of all I couldnt find a subsection for the A400, so I did not know where to put it and just created this topic over here.

I purchased the A400M via ingame marketplace (MSFS2020) and finally wanted to go for my first flight.

My problem is, that the pitch trim will always go to 45.2° UP and I cant get it to not do this.
I have a binding for trim on my hotas (Up/down button like, no wobbly wheel or something) and I can get it down to the desired 1.5°.
But some minutes later or when I try to take off and set the thrust to TOGA, it immediately jumps back to 45.2°.

Anybody facing the same issue or can help me?
Let me know if you need more information

Edited Saturday at 08:29 PM by zwackelpeter

[zwackelpeter]

I figured out what caused the issue and once more the issue sits in front of the PC.

I had a double binding on my elevator trim and the second one was -stupidity incoming- a wobbly wheel on my throttle grip.
Unbinded that, and now everything is fine.

If anybody could tell me whether there is a possibility to turn down sensitivity on rudder/tiller, I'd appreciate that.

During takeoff its hard to not oversteer.

[IniJamir]

You'd have to adjust your sensitivity in the controller-axis settings, as well as making minimal inputs on the roll. I use my stick as tiller and rudder so it takes some adjusting to.

[zwackelpeter]

11 minutes ago, IniJamir said:

You'd have to adjust your sensitivity in the controller-axis settings, as well as making minimal inputs on the roll. I use my stick as tiller and rudder so it takes some adjusting to.

In the EFB or globally in the sim?

[IniJamir]

Globally in Sim, via the Settings and Controls menus, then click the gear icons on the hardware you want to adjust

[zwackelpeter]

I am on 2020.

However, I know how to set it, 
I was just hoping I do not have to give it a seperate profile and there would be an option in the efb.

Anyway, thank you very much for your help!! 🙂