Striker problems found so far

[dBracher]

1: When clicking on the cockpit handle outside, you should spawn into the cockpit. Position is wrong. As I always find myself sat in the front window looking over the nose. This then has to be corrected by selecting Pilot in the camera settings in the EFB. see jpg below.

2:When in the correct cockpit position it's quite far back. Especially in VR.

3: As nobody has mentioned this, it might be something I'm doing wrong. But I can't turn on any MFDs or DFD screens. It says in the startup info to turn the the two knobs on the top left of each screen. They glow blue. They do nothing. Even if I start with Ctrl-E they don't come on. 

What am I missing.

Just thought I'd add I also have your 'Hunter' and that work great. 

Edited 6 hours ago by dBracher

[IniSteve]

Hi. A few replies in order - 

1. This sounds like a config conflict. Do you have custom cameras setup or use Chaseplane? 

2. The default cockpit camera is adjusted to account for the majority of monitor/POV setups, but some manual tuning (especially in VR) may be required to suit your specific use case. 

3. You should be able to rotate or drag the MFD knobs CW (clockwise) as shown in the image below 


If this isn't occurring, you might want to reinstall the package as there is a chance something got corrupted.

[dBracher]

1; No, I've no custom camara setups or chaseplane. Everything standard....and works fine with your hunter too.

2;Once in the pilot seat, through using the EFB, yes, it's easy to move my position in VR.

3;I can rotate those MFD knobs just fine....but nothing happens. Screen stays blank. Am I turning something on earlier wrong? Though when not cold and dark, even Ctrl-E doesn't start them.

Also how is the DFD screen supposed to be turned on as mentioned in the startup guide?

Flight model is good fun, just wish the screens worked. I'll try a re-install.

 

Edited 5 hours ago by dBracher

[IniSteve]

Are you powering up the bus? 
On C&D spawn, turn on ESS BUSS to supply power to the batts and then start the APU. You should then be able to turn on the MFDs 

[dBracher]

I'll check tomorrow. I think so....I followed the startup list. Is the ESS BUSS on that? Also wouldn't that also start with a Ctrl-E start? As that didn't start the  MFDs either. I started it enough to fly it around 🙂

Edited 2 hours ago by dBracher