bug Bug in DisplaySystem - 1.03

[Der Michel]

After checking the ECAM pages with BAT only powered, the system is not returning to normal Display status after powering AC.

The correct function is required if you start APU with batteries at a remote parking position.

Currently you can permanent switch to ECAM pages at the upper display. But this should only happen, while the corresponding button is pressed, and revert to normal ops, when the lower display is powered and selftest by s done.

FCOM:

If the lower ECAM display fails, or is switched off, the flight crew can display the system/status page
by :
‐ Using the “ECAM/ND XFR” switch, on the ECAM SWITCHING panel, to display it on the NDU, or
‐ Pushing and holding (for a maximum of 3 min) the related system page pushbutton on the ECAM
control panel, to temporarily display it on the upper ECAM DU (instead of the engine/warning
page)

 

Edited November 11 by Der Michel

[Der Michel]

looks like it is fixed