Honeycomb Bravo calibration problem

[sdflyer]

I have Honeycomb Bravo Quadrant set up for 4 engines. In MSFS binding each engine assigned to the axis 1,2,3,4 respectfully. My problem is when I calibrate throttles in EFB for max position, I push my physical throttles full but inside 340 the only go to  FL MCT detent. Is there a way to calibrate them properly? 

[DroneSim]

Did you calibrate the throttles in the EFB? 

[sdflyer]

6 hours ago, DroneSim said:

Did you calibrate the throttles in the EFB? 

Did you read my post? I wrote above: "My problem is when I calibrate throttles in EFB for max position"

[DroneSim]

4 hours ago, sdflyer said:

Did you read my post? I wrote above: "My problem is when I calibrate throttles in EFB for max position"

My bad. Hope you’ll find help regarding this issue