After setting flaps from 0 to 1 they cannot be set back to 0 in A359

[SirLandsALot]

Hi, Since couple of days I have this issue that when I set flaps 1 then after takeof I cannot retract them to 0. Flaps lever mouse drag doesn't work and same if I set a button for retracting flaps. They move in range 1-full. This happens in any state of aircraft. Help!

[frank_m]

Cant confirm. I have made a flight today, and retracting the flaps was no problem.

[widgeboy]

I also have this problem, and it seems to also be part of a wider glitch / failure - I was departing LHR and on taxi I noticed that the engines were very slowly increasing thrust even though I had not adjusted the levers.  The only way I could stop the increase was to repeatedly select reverse thrust.  Then on the t/o roll, the engines would not spool up as quickly as they should leading to a very long take off roll.  When airbourne I couldnt select flaps 0.  In the end I had to restart the sim and everything worked fine.............until 7 hours later on arrival - I couldn't go flaps 0 (only back to 1) - and this time, there was no response on the throttles at all - they sat at idle on the taxi in.

[SirLandsALot]

I double checked bindings and that's not the issue. When I move flaps from 0 to 1 by mouse or keys I can move them I. Range 1 to full without a problem but they do not move to 0. Also if I make a key bind for retract flaps it doesn't work. Plane starts with flaps 0 of course.