FMS 2 does not open sub menu items

[LineDX]

Hi team @iniBuilds after updating to v1.0.8. FMS2 does not open sub menus . Please have a look at the attached video. Cleared WASM. but no joy. 

Also, when loading the airplane and go inside the cockpit. hear a crashing/hammering sound for sec, like something falling hard. Did not notice in in previous builds. 

[Eddie]

Hello,

Forwarded to the team. Thank you! 🙂

[keino333]

13 hours ago, LineDX said:

Hi team @iniBuilds after updating to v1.0.8. FMS2 does not open sub menus . Please have a look at the attached video. Cleared WASM. but no joy. 

Also, when loading the airplane and go inside the cockpit. hear a crashing/hammering sound for sec, like something falling hard. Did not notice in in previous builds. 

I have a similar issue FMS1.  Clicking on the FMS F-PLN then freezes.  But all other functions in the cockpit work. (This surfaced after 1.08) 

 

Edited Wednesday at 03:25 AM by keino333

[Eddie]

5 hours ago, keino333 said:

I have a similar issue FMS1.  Clicking on the FMS F-PLN then freezes.  But all other functions in the cockpit work. (This surfaced after 1.08) 

 

Hello keino,

This is a "WASM" crash. If you are able to reliably reproduce this, please report this to us using this "template" (linked below) so that we can action it appropriately.

 

[LineDX]

1 hour ago, Eddie said:

Hello keino,

This is a "WASM" crash. If you are able to reliably reproduce this, please report this to us using this "template" (linked below) so that we can action it appropriately.

 

Had this wasm as well in FMS1. The scenario was. 

Cold and dark. Barts and external power on.

Flight Plan not loaded, no weights set. 

Click on fms1 top menu and had a wasm. 

 

But if load cold and dark, Barts and Ext 1 and 2 connected. Flight plan created/imported in OIS.weights set, chats set. No wasm on fms 1 then. Strange. Never had this issue before. 

 

Edited Wednesday at 09:29 AM by LineDX

[Eddie]

Hello,

That sounds very odd. Please refer to my previous message in that case and check if you can reproduce this, if yes, please grab us the error as described in the linked post. Thank you and again, apologies for the inconvenience. 

[LineDX]

11 hours ago, Eddie said:

Hello,

Forwarded to the team. Thank you! 🙂

Regarding the fms2 not showing/cycling sub menus. The scenario is:

 

Cold and dark startup at OTHH gate 75(stock airport). 

Over panel :set 

OIS. Flight plan imported from simbreif. 

Fuel and zfw set. 

Dep/arr charts selected. 

FMS1. Flight Plan imported/winds imported. 

Weights set. 

T/o performance done on OIS and sent to fms1

FMS 2. THE PAGES CYCLE AT THIS MOMENT. 

Surv page. Set 

ATC/com set. Kusa selected for vatsim weather. (hoppie already set). 

Update the atis. Open the atis clicking the arrow key. Then go back. AT THIS POINT FMS 2 FLT PLAN AND PERF PAGES WON'T OPEN/CYCLE AS SHOWN IN THE ABOVE VIDEO 

Edited Wednesday at 09:38 AM by LineDX