unable to set Mach SPD CSTR

[Nikolaj Delaney]

Hi, the SPD CSTR only accepts KT entry and Mach constraint is not allowed - error ENTRY OUT OF RANGE

Tried 0.8, .85 (window only accepts 3 symbols max).

[haza2]

15 minutes ago, Nikolaj Delaney said:

Hi, the SPD CSTR only accepts KT entry and Mach constraint is not allowed - error ENTRY OUT OF RANGE

Tried 0.8, .85 (window only accepts 3 symbols max).

I see 0.8 KTS not 0.8M

[Nikolaj Delaney]

2 minutes ago, haza2 said:

I see 0.8 KTS not 0.8M

yes it will not switch to MAch.

Tried .8M, M85, 85M, all "entry out of range"

Edited March 14 by Nikolaj Delaney

[haza2]

3 minutes ago, Nikolaj Delaney said:

yes it will not switch to MAch.

Tried .8M, M85, 85M, all "entry out of range"

Iv just had a look myself. Will report it to the team.

 

 

[qwe]

think a350 only takes knots there, to do what you were trying to do, you would use CMS in A350, but its not implemented in this simulation yet
 

Edited March 14 by qwe